Aegis Micro NRC 2.0.1 User Manual download pdf (Page 26)

Users’ Guide: Networked Receiver Controller - NRC-2.0.1 PAGE 26

Channel Node

Most of the functionality of the NRC Java Client is provided in the content panel when a

channel node is selected in the tree. This panel is separated into three areas:

• Connect state

Positioned at the top, this area gives the current connection state of the channel

and the ability to connect to, piggyback to or disconnect from the channel, if

applicable. If the channel is connected to another client, the network address of

that client appears. If the client is currently piggybacking the channel, the

network address of the primary client is shown.

• Receiver

o Receiver Configurable Options

The receiver section contains the current state of the configurable receiver

parameters for the receiver attached to the channel - frequency, detection

mode, AGC mode, BFO, IF Bandwidth. Each of these parameters can be

changed by entering the new value in the corresponding field and then

pressing Enter or clicking the corresponding Change button. NOTE: You

must hit the change button for new pull down options in Detection Mode

or AGC Mode to take effect.

o Samples to skip on tune

This indicates the number of audio samples to discard when changing

receiver parameters, and ensures the output signal reflects that associated

with the changed values.

o Receiver Memory Interface

The memory location interface allows the receiver’s internal memory

locations to be accessed and receiver parameters to be queried, loaded or

saved.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 41 42

No comments

Aegis Micro NRC 2.0.1 User Manual Page 26