Aegis Micro NRC 2.0.1 User Manual download pdf (Page 28)

Users’ Guide: Networked Receiver Controller - NRC-2.0.1 PAGE 28

expected from the receiver and it will be delivered back to the client. If

the box is checked but no response is generated by the receiver then the

receiver will briefly go offline while the NRC re-synchronizes

communication. If a receiver response is generated when the box is not

checked, the response is simply discarded. The “Response” box should not

be checked unless a response is required by the user.

Note: This interface should only be used by advance users who are

familiar with the impact of issuing commands directly to the receivers.

o Receiver Reset

The receiver reset button provides a receiver reset capability, although it is

important to note that the result of a reset can be different for different

receivers.

eg. Resetting the WJ-8723 receiver resets the receiver back to a known

configuration profile, while resetting the TenTec Rx331 refreshes the

receiver with its most recent user programmed settings.

o Receiver Reboot

The receiver reboot button allows a low level receiver reboot sequence to

be sent to the receiver where supported. It should be used when the

receiver has entered into some unknown state and is a last resort before a

power-off reset is tried.

The receiver reboot process also initiates a POST of the receiver and will

take about 15secs.

• Data capture

The bottom section of the content panel allows the user to capture audio data

samples from the receiver attached to this channel. Clicking the Capture button

will launch the Capture channel data dialog. While capturing, the Stop button

allows the user to stop data capture.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 41 42

No comments

Aegis Micro NRC 2.0.1 User Manual Page 28